Trendnet TEW-739APBO Instalační příručka

Ÿ N300 Outdoor PoE Access Point TEW-739APBOTEW-739APBO (V1) /06.19.2014Ÿ Quick Installation Guide (1)

9 3. Hardware InstallationWaterproof kit installation1. Unscrew the sealing nut from the main body. 2. Separate the rubber seal from the claw.Cable

10Access point installationBuildingModemInternetRouterTEW-739APBO

1. Refer to the above diagram.2. Mount the TEW-739APBOs in your desired location. Instructions for pole mounting the access point can be found in th

12Pole mounting the TEW-739APBONote: The pole mounting clamp supports poles with a maximum diameter of 78 mm (3.07 inches).1. Align the mounting brack

Company Information:Company Name:Company Address:Product Information:Product Description:N300 Outdoor PoE Access PointModel Number:Brand Name:Technica

GPL/LGPL General InformationThis TRENDnet product includes free software written by third party developers. These codes are subject to the GNU General

Общая информация о лицензиях GPL/LGPLВ состав данного продукта TRENDnet входит бесплатное программное обеспечение, написанное сторонними разработчикам

Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following length of

CertificationsThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause h

Ÿ TEW-739APBOŸ CD-ROM (User's Guide)Ÿ Multi-Language Quick Installation GuideŸ Proprietary PoE injectorŸ Power adapter (48 V DC, 0.5 A)Ÿ Mounting

2 2. Hardware ConfigurationNote: The default IP address of the TEW-739APBO is 192.168.10.100. To configure the TEW-739APBO, your network adapter must

35. Connect the other end of a network cable to your computer's Ethernet port. 6. Connect the power adapter into the Power over Ethernet Injecto

49. Enter the User name and Password, and then click OK. By default: User Name: admin Password: admin Note: Username and password are case sensi

Note: To protect your network from any unauthorized access it is recommended to enable wireless encryption.516. Select WPA2-PSK for security type.17

622. Wait 45 seconds while the Access Point reboots.21. Click Reboot.20. Click Reboot.23. Configure the TEW-739APBO's IP address to a valid

724. Click System " LAN.25. Select Static IP. 26. Configure the IP Address, IP Netmask and IP Gateway based on the example in step 23.27.

831. Click Reboot.32. Wait 45 seconds while the Access Point reboots.