Trendnet MultiTemp III 18-1106-33 Uživatelský manuál

MultiTemp®IIIUser Manual18-1106-33Edition ADAP H A R M A C I A B I O T E C H

3. Installationliquid pour into a large vessel using hydrostatic pressure. Thebath contains 3 litres of liquid, plus the volume in tubing andconnected

4. Operation4. OperationFig. 2. Front panel of MultiTemp III.1. Mode selector 6. Mains switch2. Set value down 7. Control lamp cooling on/off3. Set va

4. Operationthe external system and the level in the bath will fall. Addmore liquid until the level is once again 2 cm below the topplate. If the safe

4. Operation2. Use or to set the maximum allowed set tempe-rature. The factory pre-set value is 90.0 °C. 3. Confirm with bef

4. Operation5. Confirm with before the display returns to the actualtemperature value.Note: The new value is not saved until has been pres-sed.12

5. Trouble shooting5. Trouble shootingMessage on display Cause RemedyThe bath temperature has exceeded Pour in more liquid.the safety temperature lim

6. Maintenance6. MaintenanceWarning! Always disconnect MultiTemp III from the mains(Pull out the mains plug) before maintenance and/or service.Service

6. MaintenanceThe circuit breaker (thermal fuses) for MultiTemp III are loca-ted on the rear of the unit.Note: If the circuit breaker has been trigger

7. Detailed Description7. Detailed DescriptionMultiTemp III regulates temperature by balancing the effectsof constant cooling and controlled pulses of

7. Detailed DescriptionMains Switch. Starts the cooling compressor and the pumpmotor that circulates the temperature controlled liquid.Activates the h

Reading this entire manualis necessary for full under-standing and safe use of this product.Should you have any comments onthis manual, we will be ple

7. Detailed DescriptionGeneral cut-offThe heater, the compressor and the circulation pump can beswitched off by a relay built into the unit. This gene

7. Detailed DescriptionAccurate Setting of Temperature LimitIf a more accurate temperature limit is required, for example50 °C, follow the procedure b

7. Detailed DescriptionNote: Although this feature activates the general cut-off, it isnot a dedicated ”safety-function” of the type listedabove. When

7. Detailed DescriptionTo start MultiTemp III in 8 mode ON, follow the instructionsbelow:1. Check that all tubings are firmly connected and securedwi

8. Technical specifiations8. TechnicalspecificationsTechnical specifications (ambient temperature 20 °C)Working temperature range -10 to 90 °CTemperat

9. Ordering informationDesignation Code No.MultiTemp III 100-120 V 18-1102-77MultiTemp III 220-240 V 18-1102-78AccessoriesItem Quantity Code No.Coolin

Short instructionsNote: The following short instructions are intended as a guide to users who are fully familiar with safety procedures and operating

Contents1. Introduction... 32. Safety information ...

2

1. Introduction and 2. Safety information1. IntroductionMultiTemp®III circulates constant temperature liquid toexternal electrophoresis equipment. Th

1. Introduction and 2. Safety information7. Do not use the circulator beyond its specifications or forother than its intended use. 8. Do not touch th

1. Introduction and 2. Safety informationGeneral cut-offThe heater, the compressor and the circulation pump can beswitched off by a relay built into

3. Installation3. Installation1. Check the contents against the packing list supplied. Inspectfor any damage that may have occurred during transit. Re

3. InstallationSilicone tubing (inner diameter 8 mm) can be used over theentire working temperature range of the unit. PVC tubingcan only be used in t